:	May 12, 2004

.

: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands. Raise and support the vehicle.

.

Remove the transmission crossmember.

.

: To avoid damage to the joints or gaiters, do not allow the transmission to hang on the driveshafts. Remove the shift motor.   Lower the rear of the transmission for access.   Disconnect the electrical connector.   Remove the 4 Torx bolts.

.

Install the shift motor.   Clean the components.   Tighten the Torx bolts to 25 Nm (18 lb.ft).   Connect the electrical connector.

.

Install the transmission crossmember.

.

Use T4 to re-calibrate a new transfer case shift motor.